Subframe

Started mocking up the subframe for the bike, not quite sure if it'll work as it's the first i've built, if its not right i'll get one made after.

I used 10mm box section stainless tube

It seems a little long as it is, but i've left some room to trim it down if required.

 I'll be looking to run it on this angle

Tom (Chief) at Holme Valley Customs - www.holmevalleycustoms.com/ - sent a package of pre cut frame tabs, saved me some time trying to get them cut.
I've tacked on the two shock mounts to the mid section of the front cross bar.

Need to make the support arms to the frame but i'm happy with it so far